CORRECTION FROM SOURCE: Silver Bullet Mines Assays 30.1 ppm Gold at the Washington Mine in Idaho

In This Article:

This release corrects and replaces the press release issued by Silver Bullet Mines Corp., on May 01, 2025, 1:58 PM EDT.

Burlington, Ontario--(Newsfile Corp. - May 1, 2025) - Silver Bullet Mines Corp. (TSXV: SBMI) (OTCQB: SBMCF) ('SBMI' or 'the Company') is very pleased to report it has successfully completed the first phase of development of the Washington Mine in Idaho.

Highlights of this development include the following:

  • Successfully advanced a 12 foot x 12 foot main haulage tunnel 190 feet

  • Set up underground drill stations that will help further define the geometry of the mineralized zones

  • Successfully broke into the historical Washington Gold Workings

  • Intercepted the historical Berger Vein and the Eastern silver/gold shoot

  • Drilled several NQ holes that appear to intercept the peripheral portions of the mineralization

  • Identified two highly prospective gold/silver targets, one of which is the Subrosa

  • Exposed the original Subrosa Adit at surface

The Subrosa was historically reported to run 32 oz/ton (995.31 ppm) silver and .13 oz/ton (4.04 ppm) gold over 65 feet (see the Stoker Report mentioned numerous times in previous releases).

SBMI's own assays and XRF readings taken on site from the host rock revealed multiple high grade gold/silver veinlets throughout the host rock. Almost all of the 32 samples taken by SBMI, adjacent to the Washington vein and analyzed by ALS, were anomalous for both gold and silver, with one assay returning 30.1 ppm gold.

See table below with other highlights from host rock:

1 - 30.1 ppm gold, 14.9 ppm silver

4 - .101 ppm gold, 33.0 ppm silver

2 - .34 ppm gold, 56.7 ppm silver

5 - .117 ppm gold, 35.7 ppm silver

3 - .58 ppm gold, 97.3 ppm silver

6 - .498 ppm gold, 7.5 ppm silver

 

In management's opinion these values are significant as they occur in the host rock not normally associated with mineralized material. It should be noted that within the Washington vein, recent samples ran as high as 3,000 ppm silver.

During this phase of development the Company was able to complete the work necessary to identify the locations of all the zones as indicated in the Stoker Report (see full report on website) and to establish the potential for significant materialization at depth. SBMI is now ready to commence mining what it believes to be high grade silver/gold material from multiple targets on the property and to stockpile the mineralized material. SBMI expects to quickly be able to access the mineralized material.

SBMI also plans to carry out underground drilling that could potentially lead to a resource report in compliance with NI 43-101 standards.